Series MPCJR: One or Two Pump Control with Built-In Alternation Pump Controller provides versatile level control. Featured two additional programmable alarm contacts with front alarm light indication. Applications are oil tanks and reservoirs.

Series QPC: Multiple Loads, SOSO or FOFO Output Logic Quadraplex Pump Controller is where four pumps are required to alternate to provide equal run time on each. The loads are energized in the same manner as the SOSO sequence.

Series SLD: Shaft Seal Leak Protection Single Channel Leak Detection Relay monitors the shaft seal of a submersible pump to detect a leak before pump failure. When seal failure condition clears the relay automatically resets.

Series MPC: One or Two Pump Control with Built-In Alternation, Over Temperature Protection and Seal Failure Monitoring Pump Controller provides versatile level control. Designed for use with style level transmitters. Flexible and incorporates a user-friendly programming menu.

Series DPC: Dual Pump Protection Duplexing Pump Controller is used where two pumps are required to alternate to provide equal run time on each. Two LED indicators show the load energized by the SPDT output relay.

Series DLD: Shaft Seal Leak Protection Dual Channel Leak Detection Relay monitors the shaft seals of two submersible pumps to detect a leak before pump failure. Leak is detected by sensing the status of a float.

Series APM/MPM/PPM: 1/8 DIN Process and Flow / Rate Totalizers Dual-Line Analog Input Rate/Totalizer applies to level monitoring, pump control, flow rate indication, and process control. Designed for displaying flow rate and total from a flow meter.

Most Popular

Series MPCJR

Series MPC

Series APM/MPM/PPM

Series DPC

Questions

Question

Would a UFM-1 and a PPM-100 be a good match to monitor and total domestic water usage for an apartment building? The UFM-1 would be able to be powered from the 24VAC output from the PPM-100, correct? Would the PPM-100 be able to interpret the pulse signal from the UFM-1 and be able to totalize that data for up to 2 weeks on the onboard memory of the PPM-100?

Answer

The Model UFM-1 compact ultrasonic flowmeter sends out pulse signals which can be picked up by the Series PPM pulse panel meter. Also, the Series PPM has an isolated 24VDC power supply which the UFM-1 can use. The Series PPM meter has a 6-digit readout which means that it can read up to a million (gallons, liters, m3, etc.). After surpassing the million mark that readout will reset to zero and begin counting again. If needed, the Series PPM can be configured to read continuously, surpassing the millionth mark, by setting the conversion factor on the unit.

Related

Series PPM